Description
Application guideRequired Tools: Calculation and Application of Tree Implants: 2. Calculate the Number of Implants Needed: Divide the circumference by the recommended spacing for the product being used (3, 4 or 6 inches). If tree base is larger than measured circumference, make sure to place recommended number of implants evenly around the tree base. EXAMPLE: 40 inches circumference ÷ 4 inches implant spacing = 10 implants 3. Calculate Drill Hole Depth: The holes need to be deep enough to allow each implant to be recessed just inside the inner bark. Hole depth is determined from inside the inner bark. For proper drilling depth:
4. Gauging Drilling Depth: After drilling the first hole, use a measuring instrument (i.e. flat end of pen or pencil) as a depth gauge, insert completely into the hole and mark the depth by placing your thumb against the outer bark. Be sure to remove drill shavings from each hole. Repeat this procedure for every drilled hole. 6. Inserting the Tree Implants: Place the implant cartridge into the pre-drilled holes, simply pressing them into the tree trunk. Be sure to press the cartridges in as far as possible. Using a hammer and a flat end punch or dowel rod carefully drive the cartridge into the tree, recessing the large end slightly beneath the cambium surface, which is just below the bark. 7. Wound Dressing: The cartridge head securely plugs the small wound made to the tree trunk, however on thin barked trees (i.e. birch, fichus, etc.) it is recommended that a light wound dressing be applied over the implant site. This provides further protection until the cambium closes over. 8. Completion of Application Process: With the application process completed the natural sap flow will “systemically” absorb the chemical and distribute it throughout the tree. The active layer of cambium will soon grow over and close the implant site. The cartridges are to be left inside the tree. Notes:
2. On large trees where there is no main stem or trunk and multiple branching occurs, treat each stem as if it were a separate tree. This will assure adequate distribution of chemical through the tree.
3. When Re-treatment is necessary, place the new implants in a spiral pattern between, and above or below the previous treatment. Do not attempt to drill into and remove the cartridges implanted previously. Note the positioning of three applications. Follow Cautions Where Indicated: • Always read & follow label directions for product being used. Do Not: |
Reviews
There are no reviews yet.